Impedance Matching

This is the place for all audio-related discussions, which are not covered in any of the other sub-forums.

Impedance Matching

Postby jammyjack » Sat Jan 12, 2013 7:41 am


I have a 10" 8 ohms Woofer, 5.25" 4 Ohms Mid and 25 mm 6 ohms silk dome tweeter now I want to design a crossover which should match the impedance of all drivers and service the basic purpose of crossover (Frequency matching). Any suggestion on this. All these drivers are from Peerless.

Posts: 2
Joined: Sat Jan 12, 2013 7:34 am

Return to DIYSpeakers general discussion

Who is online

Users browsing this forum: No registered users and 2 guests