Impedance Matching

This is the place for all audio-related discussions, which are not covered in any of the other sub-forums.

Impedance Matching

Postby jammyjack » Sat Jan 12, 2013 7:41 am

HI,

I have a 10" 8 ohms Woofer, 5.25" 4 Ohms Mid and 25 mm 6 ohms silk dome tweeter now I want to design a crossover which should match the impedance of all drivers and service the basic purpose of crossover (Frequency matching). Any suggestion on this. All these drivers are from Peerless.

Regards
Justin
jammyjack
 
Posts: 2
Joined: Sat Jan 12, 2013 7:34 am

Return to DIYSpeakers general discussion

Who is online

Users browsing this forum: No registered users and 6 guests